How many times have you purchased a new pair of headphones only to figure out you didn't like the sound quality? Did you know there is something you can do about it? It's called 'burn in'. Higher quality headphones actually require a time of adjustment called burn in.
Now you don't need to know so much professional knowledge, so many complex
procedures, easy to put your headphones or speakers to best effect,prolonging the service life, and fast way is a general way of 9 times faster
The common way to burn in need to be very careful. If burn in bad word, may shorten the service life of the headset for opportunities to create permanent ear even the physical damage, such as not careful power overload, amplitude too large diaphragm pat edge, etc. Some friends in the burn in, when the amplitude too large voice coil fixed glue stoopped.press hit lead from the diaphragm sound as saying, no doubt because the volume too large vibration amplitude of the film too large and cause. The diaphragm and speakers as the speaker, has its service life, just because the amplitude of the diaphragm of the headset is very small, so the amplitude of vibration than speaker film much smaller, the life of the headset will also is longer,the normal use of words, Beats By Dre decades is no problem. But if want to quickly burn in cooked headphones, and long time of high power to drive the headphones, will shorten the headset, if the service life of the machine, is still very improper burn in may be to repair the headset physical damage, so appropriate volume to burn in headset is very important.especially high quality headphones headphones actually burn in, don’t use electronic music burn in, electronic music of the bass composition is too strong, for high sensitivity headset for possible overload, cause irreversible physical injury. In short,soft fire simmer full taste. The other is that don’t use single frequency sound signal to test headphones, especially don’t with low frequency signal measurement, one is the low frequency signal ear response is not sensitive,such as 20 Hz ac signal if you could hear, so the power must have had a headset inherit the overload, some of the low power is likely to have burned headset or appear voice coil deformation. 20 Hz ac is a limit, hear and hear in between, some ears sound is not very good people to hear, so 10 million don’t in some extreme frequency with his new headphones joneses.
Now you don't need to know so much professional knowledge, so many complex procedures, easy to put your headphones or speakers to best effect,prolonging the service life, and fast way is a general way of 9 times faster
Share with Others
- Last changed:
- Oct 28, 2011
- Average Rating:
- No data
- 6.4 MB